Metal Carriage - Revision history

Poofjunior: /* 3D Printed Parts and Settings */

2022-05-11T05:30:44Z

3D Printed Parts and Settings

Poofjunior at 05:24, 11 May 2022

2022-05-11T05:24:27Z

Poofjunior: Created page with "The metal carriage was designed and tested by @Nanotech and machined by [Mandala Rose Works http://mandalaroseworks.com/]. thumb == Specs == *..."

2022-05-11T05:23:55Z

Created page with "The metal carriage was designed and tested by @Nanotech and machined by [Mandala Rose Works http://mandalaroseworks.com/]. thumb == Specs == *..."

New page

The metal carriage was designed and tested by @Nanotech and machined by [Mandala Rose Works http://mandalaroseworks.com/].

[[File:Metal tool plate.png|thumb]]

== Specs ==
* very stiff interface between tools and the motion system
* ~93 [grams]
* accommodates both 6 [mm] and 9 [mm] belts

== 3D Printed Parts and Settings ==

Print parts specific to your setup with the following print settings:
* print in the provided orientations
* PLA
* 0.4mm nozzle
* No supports
* 0.2mm layer height
* 6 perimeter layers ← this is esp important for parts with heat-set inserts
* external perimeter first

**Table TODO**

← Older revision		Revision as of 05:30, 11 May 2022
Line 19:		Line 19:
	* external perimeter first		* external perimeter first

−	Table TODO	+	'''Table TODO'''
		+
		+	== Assembly Instructions ==
		+
		+	'''Assembly Instructions TODO'''

← Older revision		Revision as of 05:24, 11 May 2022
Line 1:		Line 1:
−	The metal carriage was designed and tested by @Nanotech and machined by [~~Mandala Rose Works~~ http://mandalaroseworks.com/].	+	The metal carriage was designed and tested by @Nanotech and machined by [http://mandalaroseworks.com/ Mandala Rose Works].

	[[File:Metal tool plate.png\|thumb]]		[[File:Metal tool plate.png\|thumb]]